Polaris RZR Hmmm...what is this?

[TNT]

Originally Posted by speedyangie

So, doing a check on Dev's RZR because his RZR keeps dying. Found two burnt wires already. Cleaned up that piece, doesn't appear to have affected anything from being dirty.

You could look at ur wire diagram chase the colored wires to that dirty piece, but don't seem like thats the prob. Usually a burnt wire is the result of too much voltage from too low a fuse, or a I call them bad line replaceable units acting like a resistor, etc. Id chased the burnt wires on your diagram to LRU or fuse see wuzz up. Wires should not be sizzling unless they are by heat.

Thats just a start.... Dying can be from alot reasons.

[TNT]

The regulator/rectifier has a heat sink and cooling fines usually mounted by the ECU/Engine that needs to be clean everyone should check...It can cause over/under voltages to the battery that would throw a code in the ECM. If you have a check engine cluster display your manual should guide u through how to access the code and isolate the issue.

[ALBANATE]

I'm going resistor module.

Nate
Alba Racing

[TNT]

Originally Posted by ALBANATE

I'm going resistor module.

Nate
Alba Racing

Hey look who finally made over to the best site on the net not that RZR.NET kiddie crap! Good calls! Good to see more top notch experience out here.

Bunch of us will be out riding @ ACORN Casino this weekend not far from u come check it out.

[ALBANATE]

Originally Posted by TNT

Hey look who finally made over to the best site on the net not that RZR.NET kiddie crap! Good calls! Good to see more top notch experience out here.

Bunch of us will be out riding @ ACORN Casino this weekend not far from u come check it out.

LOL thanks Terry. Unfortunately I am off to Phoenix for the weekend. And Steve Bielman has my RZR and is prepping it for the next round of LOORS... "The Fastest RZR in the World" is headed back to were it started. LOL

Nate
Alba Racing