front diff wiring for a rotax conversion..need help!

[bonesguy]

can anyone walk me through how to do this? did the conversion.. everything is ready to go just needs to be wired for four wheel drive.. I have the original wire loom but it is a birds nest.. where can I find schematics? or is it simple enough that someone can jsut tell me what wires go where? would like to just put to a toggle for four wheel high only.. is that possible?

[MAGNUM OFFROAD]

Be careful, wire it wrong and you will fry the actuator.

[bonesguy]

so your sayin I should I should leave it to the professionals??

Magnum.. I think you guys are close to me.. can you guys wire it for me? please send PM of what it would take.

thanks so much

[az_amsoil]

Contact BrianB...he should know

[Brian B]

Originally Posted by az_amsoil

Contact BrianB...he should know

Let Magnum take care of ya on this, or I have a harness already done for the 4wd circuit. I also have an OEM 4wd selector switch if you dont already have one!

[niko123]

brian b boneguy said if you can call him 626 347 6725 thanks

[bonesguy]

Brian B.... I do need the 4x4 switch.. not sure what happened to mine... how would the harness work? my wire loom from the Rhino is in shambles!!!! looking for the easeist/ best way to get set up.. hard part is done

tried to send you a PM but wouldnt allow me.. can you give me a call please??626-347-6725 would really appreciate it.. car is going to Aluminum guy tomorrow, would like to have the switch so we can reserve a spot for it in the dash

thanks,
Bonesguy (also a Bryan)

[bonesguy]

Does anyone know how to get a hold of Brian B?? thanks...

[07fj]

Originally Posted by bonesguy

Does anyone know how to get a hold of Brian B?? thanks...

yes, Private Message him on here