All UTV's Need a light bar fabbed up

[mosslager]

So I have a cage from Prestige Motorsports on my RZR-S. It came tabbed out for an LED bar. I am currently using those tabs on the "A" pillars for my Rigid Dually LED lights. I would like to get a 1.5" round tube light bar with bungs in each end made that would use these tabs and go across the top/front of my cage with a tab at each end for my Duallys to mount back onto and also with a pair of tabs in the center for my 10" Rigid LED bar. The 10" bar Rigid makes, uses threaded studs that come out the end of the light. By doing this the mount mus cradle the light at least on one end to get the light between the tabs. Here is a ruff diagram of what I am looking for. Can anyone help? I need to grab a couple measurements still. The overall design is really pretty basic/simple.

[BrianAshby1]

where are you located?

[mosslager]

Located in Irvine/Tustin area of OC

[BrianAshby1]

Damn if you were closer to menifee I would say bring it over and I could fab one up

[kpclarke]

i can build you a light bar. My shop is in Temecula tho. give me a call kyle Clarke (951)202-0046 KPC Fabrication

[Rusty5150]

Check the date homie. That was 2011.