Dissapointed in Kawasaki

[COGNITO]

7 months ago, bought a 2010 ecu from the dealership in Bakersfield, Fred Cummings Motorsports. i was in the process of converting my 2008 over to fuel injection using 2010 parts. ECU comes in i pick it up, take it back to the shop, open the box, and the part # on the ecu does not match the part # on the box. i take it back to fred cummings motorsports, they accuse me of swapping it out and wont do anything for me. Call Kawasaki direct, they wont do anything for me.
This week, assembling a new motor, had a problem with starter gear. Pulled side cover off and used the kawasaki flywheel puller to pull the flywheel. Get the flywheel off and notice a crack in the end of the crankshaft. I call the dealer (cheapcycleparts.com) form whom i purchased this brand new crankshaft, and they wont do anything. Call Kawasaki direct, they wont do anything for me.
BE CAREFUL who you buy your parts from! I am thoroughly dissapointed in the service i didnt get from Kawasaki. They dont give 2 licks.

[staggs]

gee that is crazy not only is it bad service from kawasaki but also it's dealers.

[Brian B]

I happen to have a new 09 EFI ECU if you still need one. You can have it Justin!

[COGNITO]

here are the pictures of the crack in the end of the crank. this crank is brand new. that key way isnt used for anything, but obviously it creates a stress point

[COGNITO]

Originally Posted by Brian B

I happen to have a new 09 EFI ECU if you still need one. You can have it Justin!

thanks anyway B, i ended up with a 2009 ecu but ordered a 2010. They are different. So i had to order another 2010 ecu, but i didnt order from the same dealer. i wont spend another penny with Fred Cummings Motorsports in Bakersfeild, CA.

i just sold the brand new 2009 ecu today.

[tatum]

Its been a while since I had mine apart but I believe I put the bolt in the end of the crankshaft after pulling off the side cover so the puller wouldnt do this to the crank.

[dmurray]

That SUCKS!!! Sorry to hear they would not make it right.

[rappy60guy]

man your luck with that rig must be frustrating. I know where theres a decent xp you can use anytime man !!!!!!!

[COGNITO]

Originally Posted by tatum

Its been a while since I had mine apart but I believe I put the bolt in the end of the crankshaft after pulling off the side cover so the puller wouldnt do this to the crank.

ya thats a good idea. i would have done that if the service manual instructed to.

[07fj]

I bet if Muzzy would have gotten one cracked they would have exchanged it!