started as a 2006 full rhino that me and my best friend Todd (owner or 151 Fab) built entirly in my own garage. No work bench, No vise, No sheet metal tools but a bead roller.
Thanks for all your guys comments and all of the great support ($$) , parts and direction from some of the Vendors on here. RUGGED RADIOS,UTV CRAP, BOOYAA CREW, UTV UNDERGROUND, KING SHOCKS, and of course 151 FABRICATION (updating the website soon). It only took me 2 years to finish this car.
List of parts on this build:
2007 R1 Motor
Custom wiring harness (only took 4 harnesses to get it right)
Completly Chromoly chassie (except the stock rhino center floor)
KarTech 930 race Axles
RBP 930 Micro stubs and Billet 4 piston calipers
Mckenzies 930 raceprep Cv's
Jeffco Reverse Box
PRP seats with 5. Crow belts
Rugged Radio- intercom w/DSP & car ro car & ipod mount
Hella 4000 HID lights w/ front light bar & actuator- all on quick release
(5) BFG Mud Terrain w/ Powder coated center line offroad racing rims
Custom mad rear rims w/ Xtreme Sand Squirts - Comp cut
Front Smoothy 28" tires
custom made KING 4 tube 2.5 X 16" rear Bypass W/ 14" 2.0 rear coil carrier
KING 3 Tube 2.5 X 14" front Bypass w/12" 2.0 front coil carrier
Braided brake lines connecting to WilWood reverse hanging pedals
Billet Gas Pedal
840c Baja Lowrance GPS
Grave Titanium mufflers - w/ ceramic coating
Custom equial Length Header w/ ceramic coating
Aluminum Tie rods connecting to a custom machined steering box
Rear LED light bar
Fluidyne Dual Pass Radiator w/ All Silicone Blue Hoses
SideWinder Chain - Rated at 18K Lbs of strength
Beard window nets
Aftermarket Hood and rear fenders - all on quick release pins
Full Belly Aluminum skid plates for Desert prerunning
18G center mounted fuel cell with Foam installed
(2) Billet fuel filters and a inline electric fuel pump w/ billet Reg.
(8) Mckenzies Limiting straps- 2 per corner
32 Peices of custom made aluminum interior and exterior
Lots of Laser cutting
Some of the features it has:
22" of rear travel (strapped short)
21" of Front travel (with absolutly no bump steer)
Custom built Trailing arms that allow the rear paddles to sit in more
Weight - Dry 1530 Lbs The car is exactly 100 Lbs havier in the rear
92" Wheel base
Laser cut and tig welded rear shock tower that was designed to stay clear of the pass and drivers head incase of a roll over.
Laser Cut and Tig welded Bulk head to match the upper front shock tower.
Light bar is Actuated
Quick pins will remove the following in seconds- rear bumper, light bar, side steps, hood, rear fenders, Steering wheel, rear LED light bar.
Tilt steering wheel.
The car seating and pedas were set up with in 1" of a brand new 09 chevy full size truck.
Custom dash - made to look similair to a old corvette
Front J-Arm suspension
I'm sure I'm forgetting about 2000 more things but You guys get the picture.
Built 100% in my garage with plenty of pics to proove it.
[ame=http://www.youtube.com/watch?v=18iwKUwcTxc]YouTube - R1 RHINO by 151 FABRICATION[/ame]