Yamaha intake or exhaust???
- Thread starter kdub41
- Start date
or screw it both lol
King is right, just save up (or flex the plastic) and get them both at the same time. Installing both mods at the same time will save you time and effort as you will only have to tune your setup once. Besides, you'll feel a definite power gain! But if you're only going to do one, I would go with exhaust and be sure you are jetted/programmed correctly.
What set-up does everyone think is the best ? I have dual pro-tec and moflow intake. Exhaust is super loud so is the intake but I like the fact the filter is out of the engine compartment getting cleaner and cooler air
Muzzys Exhaust and the K&N/BRP intake for me!!!!! Running a BRP CDI also....have not figured out what my jetting will be.......
Good luck with the Pro Tec duals. Mine are totally falling apart, can't wait to get rid of them.
Last edited:
dmc duals and rigid billet piece to allow clamp on filter. dont wast your $ on a afe- same thing one the stock lid is taking off
Funny you say that cause I cant keep the damn screws in the tip part other than that I havent had any probs besides they are loud
I had screws backing out as well, nutted some and put loc-tite on others.
But now my screws pulled through the end of the muffler. I'll post some pics when I can...the metal is crappy and basically just tore. Imagine the screws staying in place, and then something pulling the end cap clean off, tearing the end of the muffler,